Negative creep of single-crystals nickel-based superalloys

Capa

Citar

Texto integral

Acesso aberto Acesso aberto
Acesso é fechado Acesso está concedido
Acesso é fechado Somente assinantes

Resumo

The negative creep of single crystals of nickel-based superalloys SR99 and CMSX-4 has been investigated. This phenomenon was observed for both superalloys at temperatures of 980–1000 °C and low or zero loading stresses. It is assumed that the main reason for the negative creep is the formation of a short-range order of atoms in a strongly alloyed crystal lattice of the g-matrix. Additional factors affecting the magnitude and anisotropy of the negative creep strain may be the relaxation of residual stresses: at the microscopic level, misfit stresses between the g-matrix and strengthening g′-precipitates, and at the mesoscopic level, dendritic stresses between the dendrite axes and interdendritic regions.

Sobre autores

A. Epishin

Merzhanov Institute of Structural Macrokinetics and Materials Science of the Russian Academy of Sciences

Autor responsável pela correspondência
Email: a.epishin2021@gmail.com
Rússia, Chernogolovka

D. Lisovenko

Merzhanov Institute of Structural Macrokinetics and Materials Science of the Russian Academy of Sciences

Email: a.epishin2021@gmail.com
Rússia, Chernogolovka

Bibliografia

  1. Evans K., Nkansah M., Hutchinson I., Rogers S.C. Molecular network design // Nature. 1991. V. 353. P. 124. https://doi.org/10.1038/353124a0
  2. Lim T.-C. Auxetic materials and structures. Singapore: Springer, 2015. http://doi.org/10.1007/978-981-287-275-3
  3. Ren X., Das R., Tran P., et al. Auxetic metamaterials and structures: A review // Smart Mater. Struct. 2018. V. 27. № 2. P. 023001. https://doi.org/10.1088/1361-665X/aaa61c
  4. Kelkar P.U., Kim H.S., Cho K.-H., et. al. Cellular auxetic structures for mechanical metamaterials: A review // Sensors. 2020. V. 20. № 11. P. 3132. https://doi.org/10.3390/s20113132
  5. Gorodtsov V.A., Lisovenko D.S. Auxetics among materials with cubic anisotropy // Mech. Solids. 2020. V.55. № 4. P. 461–474. https://doi.org/10.3103/S0025654420040044
  6. Epishin A.I., Lisovenko D.S. Influence of the crystal structure and type of interatomic bond on the elastic properties of monatomic and diatomic cubic crystals // Mech. Solids. 2022. V.57. № 6. P. 1344–1358. https://doi.org/10.3103/S0025654422060206
  7. Ivanova S.Yu., Osipenko K.Yu., Demin A.I., Banichuk N.V., Lisovenko D.S. Studying the properties of metamaterials with a negative Poisson’s ratio when punched by a rigid impactor // Mech. Solids. 2023. V.58. № 5. P. 1536–1544. https://doi.org/10.3103/S0025654423600897
  8. Svetlov I.L., Epishin A.I., Krivko A.I., Samojlov A.I., Odintsev I.N., Andreev A.P. Anisotropy of Poisson ratio of nickel base alloy single crystals // Doklady Akademii Nauk SSSR. 1988. V. 302. № 6. P. 1372–1375.
  9. Baughman R.H., Stafström S., Cui C., Dantas S.O. Materials with negative compressibilities in one or more dimensions // Science. 1998. V. 279. P. 1522–1524. https://doi.org/10.1126/science.279.5356.1522
  10. Liu Z.-K., Wang Y., Shang S.-L. Origin of negative thermal expansion phenomenon in solids // Scripta Mater. 2011. V. 65. № 8. P. 664–667. https://doi.org/10.1016/j.scriptamat.2011.07.001
  11. Wittenberg L.J., DeWitt R. Volume contraction during melting; Emphasis on lanthanide and actinide metals // J. Chem. Phys. 1972. V. 56. P. 4526–4533. https://doi.org/10.1063/1.1677899
  12. Rittich M. The volume change during solidification. NASA Technical Memorandum TM-77817, 1982. https://ntrs.nasa.gov/api/citations/19850015932/downloads/19850015932.pdf
  13. Lakes R.S. Extreme damping in composite materials with a negative stiffness phase // Phys. Rev. Lett. 2001. V. 86. № 13. P. 2897–2900. https://doi.org/10.1103/PhysRevLett.86.2897
  14. Fountain R.W., Korchynsky M. The phenomenon of “negative creep” in alloys // Trans. ASM 51. 1959. P. 108–122. https://doi.org/10.1021/ie50595a915
  15. Timmins R., Greenwood G.W., Dyson D.F. Negative creep in a nickel-base superalloy // Scr. Metall. 1986. V.20. P. 67–70. https://doi.org/10.1016/0036-9748(86)90214-0
  16. Louchet F. A model of negative creep in nickel-based superalloys // Scripta Metall. Mater. 1995. V. 33. № 6. P. 913–918. https://doi.org/10.1016/0956-716X(95)00299-B
  17. Branch G., Draper J.H.M., Hodger J.B.M.N.W. In: International conference on creep and fatigue in Elevated Temperature Applications, Philadelphia. 1973. P. 192.1–192.9.
  18. Mayer K.H., Koenig H. In: VGB-Konferenz “Forschung in der Kraftwerkstechnik”. Essen, 1988. P. 1–24.
  19. Marucco A., Nath B. Effects of ordering on the properties of Ni-Cr alloys // J. Mater. Sci. 1988. V. 23. P. 2107–2114. https://doi.org/10.1007/BF01115776
  20. Reppich B. Negatives Kriechen // Z. Metallkd. 1984. V. 75. P. 193–202. https://doi.org/10.1515/ijmr-1984-750302
  21. Reppich B. Negatives Kriechen und Mikrogefüge langzeitexponierter Gasturbinenwerk stofle // Z. Metallkd. 1994. V. 85. P. 28–38. https://doi.org/10.1515/ijmr-1994-850105
  22. Kinzel S., Gabel J., Völkl R., Glatzel U. Reasons for volume contraction after long-term annealing of waspaloy // Adv. Eng. Mater. 2015. V. 17. P. 1106–1112. https://doi.org/10.1002/adem.201500159
  23. Firlus K., Völkl R., Gabel J., Glatzel U. The influence of Cr, Al, Co, Fe and C on negative creep of Waspaloy // Inter. J. Mater. Research. 2021. V. 112. № 2. P. 90–97. https://doi.org/10.1515/ijmr-2020-7980
  24. Ford D.A., Arthey R.P. Development of single crystal alloys for specific engine applications. Superalloys 1984, Warrendale, Pa.: Metallurgical Society of AIME. 1984. P. 115–124. https://www.tms.org/superalloys/10.7449/1984/Superalloys_1984_115_124.pdf
  25. Harris K., Erickson G.L., Sikkenga S.L., Brentall W.D., Aurrecoechea J.M., Kubarych K.G. Development of the rhenium-containing superalloys CMSX-4 & CM 186 LC for single-crystal blade and directionally solidified vane applications in advanced turbine engines // JMEP. 1993. V. 2. № 1. P. 481–487. https://doi.org/10.1007/BF02661730
  26. Lander J.J., Kern HE., Beach A.L. Solubility and diffusion coefficient of carbon in nickel: Reaction rates of nickel‐carbon alloys with barium oxide // J. Appl. Phys. 1952. V. 23. P. 1305–1309. https://doi.org/10.1063/1.1702064
  27. Link T., Epishin A., Brückner U., Portella P. Increase of misfit during creep of superalloys and its correlation with deformation // Acta Mater. 2000. V. 48. № 8. P. 1981–1994. https://doi.org/10.1016/S1359-6454(99)00456-5.
  28. Nash P. The Cr−Ni (Chromium-Nickel) system // Bulletin of Alloy Phase Diagrams. 1986. V. 7. P. 466–476. https://doi.org/10.1007/BF02867812
  29. Okamoto H. Ni-W (Nickel-Tungsten) // JPE. 1991. V. 12. № 6. P. 706. https://doi.org/10.1007/BF02645185
  30. Cury R., Joubert J.-M., Tusseau-Nenez S., Leroy E., Allavena-Valette A. On the existence and the crystal structure of Ni4W, NiW and NiW2 compounds // Intermetallics. 2009. V. 17. № 3. P. 174–178. https://doi.org/10.1016/j.intermet.2008.11.001
  31. Schmidt R., Feller-Kniepmeier M. Effect of heat treatments on phase chemistry of the nickel-base superalloy SRR 99 // Metall. Trans. A. 1992. V. 23. P. 745–757. https://doi.org/10.1007/BF02675552
  32. Hemmersmeier U., Feller-Kniepmeier M. Element distribution in the macro- and microstructure of nickel base superalloy CMSX-4 // Mater. Sci. Eng. A. 1998. V. 248. № 1–2. P. 87–97. https://doi.org/10.1016/S0921-5093(98)00516-4
  33. Link T., Epishin A., Fedelich B. Inhomogeneity of misfit stresses in nickel-base superalloys: Effect on propagation of matrix dislocation loops // Phil. Mag. 2009. V. 89. № 13. P. 1141–1159. https://doi.org/10.1080/14786430902877810
  34. Brückner U., Epishin A., Link T. Local X-ray diffraction analysis of the structure of dendrites in single-crystal nickel-base superalloys // Acta Mater. 1997. V. 45. № 12. P. 5223–5231. https://doi.org/10.1016/S1359-6454(97)00163-8
  35. Epishin A., Link T., Brückner U., Fedelich B. Residual stresses in the dendritic structure of single crystal nickel-based superalloys // Phys. Met. Metallogr. 2005. V. 100. № 2. P. 192–199.
  36. Epishin A., Fedelich B., Finn M. et. al. Investigation of elastic properties of the single-crystal nickel-base superalloy CMSX-4 in the temperature interval between room temperature and 1300C // Crystals. 2021. V. 11. № 2. P. 152. https://doi.org/10.3390/cryst11020152
  37. Epishin A.I., Lisovenko D.S. Comparison of isothermal and adiabatic elasticity characteristics of the single crystal nickel-based superalloy CMSX-4 in the temperature range between room temperature and 1300C // Mech. Solids. 2023. V. 58. № 5. P. 1587–1598. https://doi.org/10.3103/S0025654423601301.
  38. Epishin A., Link T., Nazmy M., Staubli M., Klingelhöffer H., Nolze G. Microstructural degradation of CMSX-4: kinetics and effect on mechanical properties, Proceedings of 11th International Symposium “Superalloys 2008”, ed. by R. C. Reed et al., TMS, Warrendale, Pennsylvania, USA, 2008. P. 725–731. https://doi.org/10.7449/2008/Superalloys_2008_725_731

Arquivos suplementares

Arquivos suplementares
Ação
1. JATS XML
Baixar

Declaração de direitos autorais © Russian Academy of Sciences, 2024